Wednesday, 12 April 2017

CLASS 10 / EXPERIMENT-1/ VERIFICATION OF OHM'S LAW

                                       CLASS 10 / EXPERIMENT - 1

VERIFICATION OF OHM'S LAW


Objective:

To verify the Ohm's law.

Statement of Ohm's Law:

Ohm’s law states that at a constant temperature, current 'I' through a conductor between two points is directly proportional to the potential difference or voltage 'V', across the two points.  
                                     V = IR
Thus, the ratio V : I is a constant. This constant is called as the resistance (R) of the conductor.
Graph:
After performing experiment for different readings of V & I and recording the observations, if we plot current on the x-axis of a graph and voltage on the y-axis of the graph, we will get a straight-line. The gradient of the straight-line graph is related to the resistance (R) of the conductor.

Related Theory:

Resistance:

  • Resistance is the property of a component which restricts the flow of electric current. Energy is used up as the voltage across the component drives the current through it and this energy appears as heat in the component.
  • Resistance is measured in ohms, the symbol for ohm is an omega(Ω).

Resistors connected in Series:

When resistors are connected in series their combined resistance is equal to sum of thier the individual resistances. For example if resistors R1 and R2 are connected in series their combined resistance, R, is given by:
R = R1+R2

Resistors connected in Parallel:

                              When resistors are connected in parallel their combined resistance is less than any of the individual resistances. Equation for the combined resistance R of 2 resistors R1 and R2 connected in parallel is given by:
                                       frac{1}{R}=frac{1}{R1}+frac{1}{R2}      OR       R =frac{1}{frac{1}{R1}+frac{1}{R2}}
       Material required :
                     A resistor of about 5 Ω, an ammeter ( 0 - 3 A), a voltmeter (0 - 10 V), four dry cells of 1.5 V each with a cell holder (or a battery eliminator), a plug key, connecting wires, and a piece of sand paper.


       Circuit diagram:

Procedure :

  1. Draw the circuit diagram as shown above.
  2. Arrange the apparatus as per the circuit diagram.
  3. Clean the ends of the connecting wires with sand paper and make them shiny.
  4. Make the connections as per circuit diagram. All connections must be neat and tight. Take care to connect the ammeter and voltmeter with their correct polarity. (+ve to +ve and -ve to -ve).
  5. Determine the zero error and least count of the ammeter and voltmeter and record them.
  6. Adjust the rheostat to pass a low current.
  7. Insert the key K and slide the rheostat contact to see whether the ammeter and voltmeter are showing deflections properly.
  8. Adjust the rheostat to get a small deflection in ammeter and voltmeter.
  9. Record the readings of the ammeter and voltmeter.
  10. Take atleast six sets of readings by adjusting the rheostat gradually.
  11. Plot a graph with V along x-axis and I along y-axis.
  12. The graph will be a straight line which verifies Ohm's law.
  13. Determine the slope of the V-I graph. The reciprocal of the slope gives resistance of the wire.

Observations:

  • Range of the given ammeter=.................... A.
  • Least count of the given ammeter = ..................... A.
  • Range of the given voltmeter = .....................V.
  • Least count of the given voltmeter = .....................V.
  • Mean value of V/I from observations, R = .......... Ω.

Observation from graph:

  • Slope of I vs V graph = ...........
  • R from graph = 1/ slope = .............. Ω.
                                  

Observation table:

Precautions :

  • All the electrical connections must be neat and tight.
  • Voltmeter and Ammeter must be of proper range.
  • The key should be inserted only while taking readings.




Tuesday, 11 April 2017

CLASS 9 / PHYSICS / VIDEO LINKS / MOTION

CLASS 9 / PHYSICS
CHAPTER – MOTION
(VIDEO LINKS)
KINDLY VISIT THE FOLLOWING LINKS TO ACCESS THE VIDEOS RELATED TO THE TOPIC – MOTION

INTRODUCTION TO PHYSICS:




TYPES OF MOTION:



UN IFORM AND NON-UNIFORM MOTION:
















CLASS 6 / MATHS / WORKSHEET-1

ARMY PUBLIC SCHOOL, GOLCONDA
CLASS – 6 / MATHS
CHAPTER – 1 / KNOWING OUR NUMBERS
WORKSHEET – 1

Q1. Write the numbers in according to Indian or international system of numeration in words
a) 19,15,60,050
 b) 20,48,74,873
 c) 97,97,97,997
 d) 507,476,123
 e) 100,005,567

Q2. Write the numbers in according to Indian or international system of numeration in numerals
a) Five crores,five lakhs,five thousands
b) Fifty six crores,nineteen lakh,eight thousand and fifteen
c) One hundred ten million,two hundred thousand and three hundred forty eight
d) Two hundred thirty four million,eighteen thousand and three hundred forty eight
e) One million,one thousand and one
f) One crore,one lakh,one thousand,one hundred and one

Q3. Write each of the following in the Expanded notation form
a) 8,40,32,167
 b) 90,909,090
c) 17,865,432
 d) 6,05,43,091
 e) 10,00,976

 Q4. Write the Expanded notation form in numerals for the following-
 a) 1,00,00,000+70,00,000+6,00,000+40,000+3,000+800+20+5
 b) 4×10,00,000+6×100,000+3×10,000+7×1000+1×100+7×10
 c) 90,00,000+40,000+3000+20+6
 d) 8×10,00,000+6×1000+3×10+1.

Q5. How many numbers exist between 51 and 100?

Q6. How many thousands make a million?

Q7. How many millions make a billion?

Q8. How many lakhs make a million?

Q9. How many millions make ten crores?

Q10. Fill in the gap:
a. 1 crore=_____lakhs
b. 1 Millions=______thousands
c. 10 crores=_______millions

d. 1 Hundred thousand=______lakhs 

CLASS 6 / MATHS / WORKSHEET-2

ARMY PUBLIC SCHOOL, GOLCONDA
CLASS – 6 / MATHS
CHAPTER – 1 / KNOWING OUR NUMBERS
WORKSHEET – 2

Q1. Determine the difference of the place values of two 7’s in 257839705

Q2. Write the smallest three digits numbers which does not change if the digits are written in reverse order.

Q3. Find the difference between the number 279 and that obtained by reversing its digits.

Q4. Write the greatest 7-digit having three different digits.

Q5. Find the difference of the place value and the face value of the digits 2in 3124698.

Q6. Write all possible three digit numbers using the digits 6,0,4,when
(1) Repetition of the digits are not allowed
(2) Repetition of the digits are allowed

Q7. Determine the product of the place values of two 5’s in 259659 .

Q8. In a four digit number the digit at the thousand’s place is 4 and the digit in the one’s place is twice that in the thousand’s place. The numbers has no hundreds. The ten’s place digit is the difference between the digits in the thousand’s place and the hundred’s place .Find the number.

Q9. Which digits have the same place value and the face value in 67821904 ?

Q10. A certain nine digit number has only ones in ones period, only two’s in the thousand period and only threes in millions period .Write this number in words in the Indian system.


Q11. Find the sum of the greatest and the least numbers that can be written using the digits 9,8,0,6,4 each only once .

Friday, 7 April 2017

CLASS 10 / PHYSICS / ELECTRICITY( ELECTRIC CURRENT) / WORKSHEET-1

Class 10 – Physics
 Ch 12 – Electricity
(WORKSHEET - 1)
Subtopic – (12.1) Electric current and circuit








MCQ's
1.  One coulomb charge is equivalent to the charge contained in :

(a) 2.6 x 1019 electrons
(b) 6.2 x 1019 electrons
(c) 2.65 x 1018 electrons
(d) 6.25 x 1018 electrons

2.  Which of the following units could be used to measure the electric charge?

(a) Ampere
(b) Joule
(c) Volt
(d) Coulomb

3.  Which of the following units could be used to measure the electric current?

(a) Ampere
(b) Joule
(c) Volt
(d) Coulomb

4.  Device used to detect electric current in circuit-

(a) Galvanometer
(b) Ammeter
(c) Voltmeter
(d) Barometer

5.  Device used to measure electric current in circuit-

(a) Galvanometer
(b) Ammeter
(c) Voltmeter
(d) Barometer

6.  The resistance of Ammeter should be-

(a) Small
(b) Large
(c) Very large
(d) Doesn’t matter

7.  In an electric circuit Ammeter should be connected in-

(a) Series
(b) Parallel
(c) both (a) and (b)
(d) neither (a) nor (b)

8.  For current to flow through a circuit, the circuit must be__________.

(a) Closed
(b) Open
(c) Can’t say depend on circuit
(d) All above

9.  Which of the following equations shows the correct relationship between electric units?

(a) 1 A = 1 C / sec
(b) 1 C = 1 A / sec
(c) 1 A = 1 C x 1 sec
(d) 1 C = 1 A x 1 sec

10.     Which of the following relation are correct

(a) 1 m A = 10-3 A and 1 µA = 10-3 A
(b)
1 m A = 10-3 A and 1 A = 10-6 µA
(c)
1 µA = 10-3 A and 1 m A = 10-3 A
(d)
1 m A = 10-3 A and 1 µA = 10-6 A
  

NUMERICAL
1.  A radio set draws a current of 0.36 A for 15 minutes. Calculate the amount of electric charge that flows through the circuit? ( ans = 324 C )
2. If the charge of an electron is 1.6 x 10-19 coulomb, how many electrons should pass through a conductor in 1 second to constitute 1 ampere of current?
( ans = 6.25 x 1018 electrons)  
3. If 18400 C of charge flows through an air conditioning unit every hour, what current does it draws? ( ans = 5.1 A )           
4. A current of 3 A flows into a television set. For how long would it take 1500 C of charge to flow through it? ( ans = 500 sec )           
5. How many electrons are flowing per second past a point in a circuit in which there is a current of 5 ampere? ( ans = 31.25 x 1018 )











CLASS 10 / PHYSICS / ELECTRICITY( ELECTRIC CURRENT) / NOTES

Class 10 – Physics
 Ch 12 – Electricity

Subtopic – (12.1) Electric current and circuit

# STATIC AND CURRENT ELECTRICITY
Static electricity deals with the electric charges at rest while the current electricity deals with the electric charges in motion.

# CONDUCTOR
A substance which allows current to pass through it easily is called a conductor. It offers a low resistance to the flow of current. E.g. aluminum, copper, silver etc.

# INSULATOR
A substance with infinite high resistance and does not allow electric current to flow through it. E.g. glass, rubber, plastic etc.

# ELECTRIC CHARGE
     ·        It is physical property of matter.
     ·        Denoted by the letter ‘Q’
     ·        There are two types of electric charge – positive and negative (mostly carried out by electron and proton).
     ·         Electron are said to be carried negative charge and proton are said to carry positive charge.
     ·         By convection, the charge acquired by a glass rod rubbed with silk rod is called positive charge and the charge acquired by ebonite rod rubbed with a woolen cloth is called negative charge.
     ·         NOTE- Like charges repel and unlike charges attract each other.

# COULOMB
     ·        It is the S.I unit of charge.
     ·        Denoted as coulomb or ‘C’.
     ·        One coulomb is equivalent to the charge of approximately 6.242 x 1018 electrons.
     ·        Charge of an electron is -1.6 x 10-19 and charge of proton is +1.6 x 10-19.
     Thus, one coulomb = (6.242 x 1018) X (1.6 x 10-19)
     ·        Also, charge accumulated on conductor, is given by

Q = n.e

Where, n = no. of electron
e = charge of an electron = 1.6 x 10-19

          # ELECTRIC CURRENT
     ·        The flow of electric charge constitutes an electric current.
     ·        It is defined as the rate of flow of electric charge across a cross section of a conductor OR amount of charge flowing per unit time across a cross section of a conductor.
    Thus, electric current = charge accumulated / time taken

I = Q / t

Where, I = electric current
Q = electric charge
t = time taken
     ·        Electric current is a scalar quantity.
     ·        S.I unit of electric current is Ampere, denoted as ‘A’.
     ·        One ampere – if one coulomb of charge flows through any cross section of conductor in one second, then the current through the conductor is said to be one ampere.
1 ampere = 1 coulomb / 1 second
     ·        1 milli-ampere = 1 mA = 10-3 A
     ·        1 microampere = 1 µA = 10-6 A

# ELECTRIC CIRCUIT
The closed path along which electric current flows is called an electric circuit.

# CONVENTIONAL CURRENT
     ·        Conventionally, the direction of flow of positive charge is taken as the direction of electric current.
     ·        The conventional direction of electric current is from positive terminal of a battery to negative terminal of battery.
     ·        The actual flow of electron is from negative terminal of battery to positive terminal. Thus, direction of conventional current is opposite to the direction of flow of electrons.

# GALVANOMETER
It is a device used to detect current in an electric circuit.

# AMMETER
     ·        It is a device used to measure current in an electric circuit.
     ·        It is always connected in series in a circuit.
     ·        It should have low resistance.